Suceava — livrare în toată România Zilnic 08:00–17:00 Locație 0751 478 912
Superior DoorProtect Plus Jeweller – Alarmă
Ajax · Alarmă · Opening detectors

Superior DoorProtect Plus Jeweller – specificații și firmware

Ajax nu publică un fișier de firmware pentru acest model.
Înainte de actualizare: verifică pe eticheta aparatului modelul exact și versiunea hardware și folosește firmware-ul din regiunea aparatului (de exemplu Global sau Europa). Un firmware greșit poate bloca aparatul. Nu întrerupe alimentarea în timpul actualizării.

Superior DoorProtect Plus Jeweller este o componentă de sistem de alarmă Ajax din categoria „Opening detectors”.

Printre caracteristicile tehnice se numără funcționare între −10 și +40 °C. Fizic, cântărește 37 g și are dimensiunile 103 × 22 × 21 mm.

Nu există un firmware public de la Ajax pentru Superior DoorProtect Plus Jeweller. Mai jos scrie cum se actualizează.

Specificațiile complete, cu etichetele traduse în română, sunt în tabelul de mai jos.

Cum se actualizează Superior DoorProtect Plus Jeweller

Ajax nu publică fișiere de firmware; actualizarea se face prin hub/aplicația Ajax.

Ajax nu publică fișiere de firmware: dispozitivele se actualizează automat prin hub, iar hub-ul primește noile versiuni OS Malevich prin internet, fără intervenția utilizatorului.

Dacă producătorul publică pe viitor un fișier de firmware pentru acest model, îl adăugăm automat pe această pagină.

Specificații Superior DoorProtect Plus Jeweller

Comunicație

Superior Jeweller data transfer protocolProprietary wireless protocol for transmitting commands, alarms, and events.
Key features:
- Two-way communication.
- Advanced sabotage protection.
- Enhanced block encryption with a dynamic key.
- Instant notifications.
- Remote control and configuration in Ajax apps.
Superior Jeweller is available for devices with the 6.66.1.7 firmware version or later.
Benzi de frecvență865.0–868.0 MHz
868.0–868.6 MHz
868.7–869.2 MHz
869.4–869.65 MHz
For devices with the firmware version 6.66.1.7 or later. Devices with previous firmware versions operate only on the 868.0–868.6 MHz frequency band.
Putere maximă radiată (ERP)Până la 20 mW
Automatic power control to reduce power consumption and radio interference.
Modulație semnal radioGFSK
Rază de comunicație radioPână la 3,000 m
Between the device and a hub (or a range extender) in an open space. Communication range depends on the hub model. To support Superior Jeweller, the device must run firmware version 6.66.1.7 or later.
Comunicație criptatăAll stored and transmitted data is protected with advanced encryption, ensuring both confidentiality and integrity.
Salt de frecvențăTo prevent radio interference and jamming.

Detecție

Sensitive elements1 accelerometer
2 reed switches
The magnet can be installed to the left or right side of the detector.
Magnetssmall and big one come in the set
The small magnet operates at a distance of up to 1 cm from the detector, and the big magnet — up to 2 cm
Protection against reed switch chatteringThe detector ignores vibrations lasting up to 0.15 s.
Input to connect an additional detectorWired detector with the normally closed (NC) contact type.
Shock sensor sensitivity3 levels
The detection radius depends on the material type:
- Framed glass window — 1.2 m (high sensitivity level), 1 m (low sensitivity level).
- Wooden plate — 1.2 m (high sensitivity level), 1 m (low sensitivity level).
- Concrete plate — 0.75 m (high sensitivity level), 0.5 m (low sensitivity level).
The smoother and cleaner the detection surface is, the better the detection radius is.
Option to ignore single shockAdjusted by PRO or user with admin rights in the Ajax app.
Tilt sensor activation thresholdfrom 5° – 25°
Adjusted by PRO or user with admin rights in the Ajax app.
ChimeThe siren makes a special sound to notify that the opening detectors are triggered when the system is disarmed.
Reed switch
Additional detector connection
Shock sensor sensitivity

Recomandări

Do not install the detector using both magnets at the same time. The detector recognizes only one magnet on one side of the detector — left or right. For indoor use only.

Protecție anti-sabotaj

Alarmă anti-sabotajNotifications on attempts to detach the detector from the surface or remove it from the mounting panel.
Holding screwto secure the detector on SmartBracket
Protecție anti-spoofingAutentificare dispozitiv
Detecție pierdere comunicațieafter 36 s
Detection time depends on the Jeweller or Jeweller/Fibra settings.

Alimentare

Baterie1 × CR123A
Pre-installed.
TipType C
Autonomie estimată a baterieiPână la 5 years
Detector’s operating voltage range2.1−3.3 V⎓
Detector’s nominal operating voltage3 V⎓
Quiescent detector’s current consumption at nominal voltage0.013 mA
Maximum detector’s current consumption at nominal voltage10.5 mA
Full capacity1,600 mAh
Tensiune la baterie descărcată2.5 V⎓
Tensiune de revenire după descărcare2.7 V⎓
Tensiune baterie la final de viață2.1 V⎓
Device is switched off.
Capacitate baterie la final de viață300 mAh
ProducătorPanasonic

Carcasă

Detector dimensions103 × 22 × 21 mm
Dimensions of the big magnet103 × 22 × 21 mm
Dimensions of the small magnet55 × 11 × 6 mm
Greutate (varianta albă)37 g
Greutate (varianta neagră)34 g
Interval temperatură de funcționarefrom -10 °C – +40 °C
Umiditate de funcționarePână la 75%
Clasă de protecțieIP50, IK04

Culori

Negru
Alb

Conținut set

Superior DoorProtect Plus Jeweller
SmartBracket mounting panel with holding screw
CR123A battery (pre-installed)
Big magnet
Small magnet
Outside-mounted terminal clamp
Kit de montaj
Ghid de pornire rapidă

Standarde și certificări

Conformitate cu standardele de alarmăEN 50131-1:2006 / A1:2009 / А2:2017 / A3:2020
EN 50131-2-6:2008
EN 50131-2-8:2016
EN 50131-5-3:2017
EN 50131-6:2017 / A1:2021**
PD 6662:2017*
Certificate issued by TREZOR TEST s.r.o.
Grad de securitate (SG)2
Certificate issued by TREZOR TEST s.r.o.
Directiva REDEN 300 220-1 V3.1.1
EN 300 220-2 V3.2.1
Certificate issued by MiCOM Labs
Directiva RoHSEN IEC 63000:2018
Test report issued by Shenzhen NTEK Testing Technology Co.
Directiva EMCEN 301 489-1 V2.2.3
EN 301 489-3 V2.1.1
Certificate issued by MiCOM Labs
Directiva de joasă tensiune (LVD)EN 62479:2010
EN 62368-1:2020+A11:2020
Certificate issued by TREZOR TEST s.r.o.
Clasă de mediu conform EN 50131||
Certificate issued by TREZOR TEST s.r.o.
INCERTT 031:2017+A1:2018+A2:2022
Certificate issued by Kiwa Nederland B.V.
SSFSSF 1014v5: Larmklass R
Certificate issued by Svensk Certifiering Norden AB
PSTI UKSchedule 1
Certification NF&A2P – 2 Boucliers suivant le référentiel NF324-H58NF324-H58
NF EN 50131-2-6
RTC 50131-2-6
NF EN 50131-5-3
RT 48-228
NF EN 50130-4
NF EN 50130-5
Organismes certificateurs :
www.cnpp.com
www.marque-nf.com
Certificat №: 2324050007

Compatibil cu

EN54 Fire Hub Jeweller, EN54 Fire ReX Jeweller, Hub 2 (2G) Jeweller, Hub 2 (4G) Jeweller, Hub 2 Plus Jeweller, Hub BP Jeweller, Hub BP Jeweller (without casing), ReX 2 Jeweller, ReX Jeweller, Superior Hub G3 Jeweller, Superior Hub Hybrid (2G), Superior Hub Hybrid (4G), Superior Hub Hybrid (4G) (without casing), Superior Hub Hybrid 2, Superior Hub Hybrid 2 (without casing), Superior MegaHub, Superior MegaHub (without casing), Superior ReX G3 Jeweller

Specificațiile sunt cele publicate de Ajax, cu etichetele traduse în română (preluate la 02.11.2026). Ce nu am tradus a rămas în engleză.

Documente oficiale

Denumiri și variante: Superior DoorProtect Plus, DP.SP.J

Modele din aceeași serie

Caută alt model